Flipper Zero NRF24 Module Setup Guide
Flipper Zero NRF24 Module Setup Guide
This guide covers the PINGEQUA NRF24 2.4 GHz GPIO module for Flipper Zero.
Compatibility
Host: Flipper Zero
Radio chip: NRF24L01+ 2.4 GHz
Firmware: compatible Flipper firmware with NRF24 app support
Host: Flipper Zero
Radio chip: NRF24L01+ 2.4 GHz
Firmware: compatible Flipper firmware with NRF24 app support
Installation
- Power off your Flipper Zero.
- Insert the NRF24 module into the GPIO header in the correct orientation.
- Power on Flipper Zero.
- Open a compatible NRF24 app from your firmware's GPIO or Apps menu.
- If the app asks for connection mode, select the mode that matches your GPIO/SPI configuration.
Recommended Checks
- Update your Flipper firmware before testing.
- Confirm that the module is fully seated on the GPIO pins.
- Use the included or frequency-matched antenna when applicable.
Troubleshooting
- Module not detected: check GPIO orientation, firmware support, and app settings.
- Short practical range: 2.4 GHz devices often use frequency hopping, low transmit power, and interference-resistant designs. Limited range can be normal.
- App compatibility issue: some apps use fixed pin definitions. Try another compatible firmware build or app version.
Responsible Use Notice:
This product is intended for authorized testing, learning, hardware development and lab research only. Always follow local laws and only test systems or devices you own or have permission to use.
This product is intended for authorized testing, learning, hardware development and lab research only. Always follow local laws and only test systems or devices you own or have permission to use.
Need Help?
Email: support@pingequa.com
Please include your order number, product model, firmware version, and a clear photo of your setup.