Flipper Zero 2-in-1 Module
Flipper Zero RF 2-IN-1 Quick Guide
Operation demonstration
1. Setup (Momentum FW) Before installation
Go to: START → PROTOCOLS → GPIO PINS
Set NRF24 SPI to [Extra 7] (Required)
2. Install
Power OFF your Flipper Zero.
Insert module into LEFT GPIO headers.
Power ON.
3. Enable CC1101 (433MHz)
Go to: Sub-GHz → Radio Settings → Module
Select: [External]
4. Use NRF24 (2.4GHz)
Run apps like MouseJacker directly.
(If fails, re-check Step 1)
⚠️ COMPATIBILITY NOTICE
Smart Auto-Switch: No physical switch needed.
Known Issue: Apps like NRF24 Scanner & Jammer use hardcoded pins and WILL NOT WORK. Not a Defect: This is a software limitation, not a hardware failure. We are working with devs on updates.
Smart Auto-Switch: No physical switch needed.
Known Issue: Apps like NRF24 Scanner & Jammer use hardcoded pins and WILL NOT WORK. Not a Defect: This is a software limitation, not a hardware failure. We are working with devs on updates.
Disclaimer: Educational use only. User assumes all legal liability.